The new Harry Joyce 100 watt amplifier is an A-B class amplifier. These are all point to point, hand wired. Built right here in the United States of America under the watchful eye of George Scholz.
Material:
– 18 mm Marine grade Birch plywood
– Solid dove tail construction
All Harry Joyce Amps features include:
– Stainless steel chassis
– Enlarged filtering in power and bias supply
– Ceramic tube sockets
– Improve shielding & layout
– Hum balance
It provides 4 inputs:
– Normal Hi/Low
– Brilliant Hi/Low
This Harry Joyce Custom 100 watt amplifier is a master volume design which includes:
Gain controls for Normal or Brilliant inputs, Tone controls for Bass, Treble, Mids and Presence. The pre-amp stage uses (4) 12AX7 Pre-amp tubes for inputs, tone, voltage amp, and driver. The output stage (output transformer) is designed for EL34HJ power tubes.
On the back side, voltage and ohm selector, 2 speaker outputs (in parallel) and Hum balance, send and return effect loop ( TRS -Tip return and Ring send ), as well as, fuse holders for power and IEC Filtered Power Entry Module.
Grand Master volume
Our new Grand master feature allows you to attenuate post master volume, resulting in higher gain and lower volumes as you attenuate, helping you achieve the perfect amount of gain at the appropriate level on stage or in the studio.
Dual status indicators
The Blue LED indicates line voltage present.
The Green LED Indicates high voltage present.
This is a helpful tool since a loss of high voltage is a blown fuse most likely cased by a faulty tube.
On the back side, voltage selector is now inside for safety and industrial grade ohm selector, 2 speaker outputs (in parallel) and Hum balance, send and return (effect loop), as well as, our military grade fuse holders for power, high voltage supply and IEC Filtered Powered Entry Module.
Specs for Harry Joyce Custom 100 Watt amplifier:
Input resistance-High: 1 meg ohm
Input resistance-Low: 100 K ohm
Inputs can be linked from channel to channel
Tone controls:
Bass + minus -20 db
Treble -6 to 30 db with presence
Middle +10 db
100 Watt Amplifier
Output Power RMS: 100 Watts
Input Volt Selector: 120 Vac, 230 Vac 50/60 HZ
Output Ohm Selector: 4, 8, 16 ohms
Effect Loop: -Send through master output, return input 1 meg ohm
Preamp Tube: 4x 12AX7
Power Tube: 4x EL34
Fuse Power: 4 A slow acting
Fuse High Voltage: 1 A fast acting
